Post by spottedhaggis » Mon May 12, 2014 4:29 pm

Hi all

I know there are several pretty good looking addons that allow the customer to select from pre-defined entries to then build the product, however I am looking for something like the following.

Customer enters the following options

Length (mm)
Depth (mm)
Height (mm)
Single or double (Y/N)

These are measurements, and the the price is by volume so need to be able to calculate volume based on the user entries. I initialy thoguht I could have a table that has values from 10mm up to 2000mm for length, depth and height, but still need to figure out how to get the system to do the maths and calculate the actual volume, then I need the price to be based on the volume.

Any of you clever folks got any ideas?

Active Member


Tue Jun 26, 2012 11:20 pm

Post by geronimo13 » Mon May 12, 2014 5:05 pm

I don't know but I'm looking for something similar.



Mon May 12, 2014 5:01 pm

Post by victorj » Mon May 12, 2014 8:48 pm ... M-3-zijdig

have a look at the link above, here calaculation is for leght, but can be altered for volume.

Koeltechnische deurrubbers eenvoudig online op maat bestellen.
Alle niet stekplichtige onderdelen zoals scharnieren, sloten, randverwarming en verlichting voor alle typen koelingen en vriezers.

User avatar
Expert Member


Sat Jun 25, 2011 4:09 am
Location - Alkmaar Holland
Who is online

Users browsing this forum: No registered users and 8 guests