Post by a_sun » Wed Jan 06, 2010 2:39 pm

Hi,
PLEASE HELP!
I faced an Error message before finishing installation. And I try to go Myphpadmin check the database table, all table are already there, but if I try to go admin or store, both pages shown "Cannot found the page".

Warning: fopen(E:\wwwusr\vhosts\easternprinters.com\httpdocs\vastprint/config.php) [function.fopen]: failed to open stream: Permission denied in E:\wwwusr\vhosts\easternprinters.com\httpdocs\vastprint\install\controller\step_3.php on line 42

Warning: fwrite(): supplied argument is not a valid stream resource in E:\wwwusr\vhosts\easternprinters.com\httpdocs\vastprint\install\controller\step_3.php on line 44

Warning: fclose(): supplied argument is not a valid stream resource in E:\wwwusr\vhosts\easternprinters.com\httpdocs\vastprint\install\controller\step_3.php on line 46

Warning: fopen(E:\wwwusr\vhosts\easternprinters.com\httpdocs\vastprint/admin/config.php) [function.fopen]: failed to open stream: Permission denied in E:\wwwusr\vhosts\easternprinters.com\httpdocs\vastprint\install\controller\step_3.php on line 81

Warning: fwrite(): supplied argument is not a valid stream resource in E:\wwwusr\vhosts\easternprinters.com\httpdocs\vastprint\install\controller\step_3.php on line 83

Warning: fclose(): supplied argument is not a valid stream resource in E:\wwwusr\vhosts\easternprinters.com\httpdocs\vastprint\install\controller\step_3.php on line 85

Warning: Cannot modify header information - headers already sent by (output started at E:\wwwusr\vhosts\easternprinters.com\httpdocs\vastprint\install\controller\step_3.php:42) in E:\wwwusr\vhosts\easternprinters.com\httpdocs\vastprint\system\engine\controller.php on line 22

New member

Posts

Joined
Tue Dec 29, 2009 5:22 pm

Post by Xsecrets » Wed Jan 06, 2010 9:57 pm

that's a permissions issue for whatever reason your config.php files are not readable by the webserver user.

OpenCart commercial mods and development http://spotonsolutions.net
Layered Navigation
Shipment Tracking
Vehicle Year/Make/Model Filter


Guru Member

Posts

Joined
Sun Oct 25, 2009 3:51 am
Location - FL US

Post by a_sun » Thu Jan 07, 2010 2:24 pm

ok. solved!
thanks.

New member

Posts

Joined
Tue Dec 29, 2009 5:22 pm
Who is online

Users browsing this forum: No registered users and 6 guests