Page 1 of 1

Custom product design module

Posted: Mon May 12, 2014 4:29 pm
by spottedhaggis
Hi all

I know there are several pretty good looking addons that allow the customer to select from pre-defined entries to then build the product, however I am looking for something like the following.

Customer enters the following options

Length (mm)
Depth (mm)
Height (mm)
Single or double (Y/N)

These are measurements, and the the price is by volume so need to be able to calculate volume based on the user entries. I initialy thoguht I could have a table that has values from 10mm up to 2000mm for length, depth and height, but still need to figure out how to get the system to do the maths and calculate the actual volume, then I need the price to be based on the volume.

Any of you clever folks got any ideas?

Re: Custom product design module

Posted: Mon May 12, 2014 5:05 pm
by geronimo13
I don't know but I'm looking for something similar.

Re: Custom product design module

Posted: Mon May 12, 2014 8:48 pm
by victorj
http://www.koelcel-onderdelen.com/Indru ... M-3-zijdig

have a look at the link above, here calaculation is for leght, but can be altered for volume.